V150ZA4PX2855 Varistors - ZA Series - Low to Medium Voltage Radial Leaded Varistor

Part Number: V150ZA4PX2855

Series: ZA

ZA Series Data Sheet
Littelfuse_MOV_ZA.pdf
(694,514 bytes)
Last Uploaded: February 09, 2012

ZA Series - Low to Medium Voltage Radial Leaded Varistor

The ZA Series of transient voltage surge suppressors are radial-lead varistors (MOVs) designed for use in the protection of low and medium-voltage circuits and systems. Typical applications include motor control, telecom, automotive systems, solenoid, and power supply circuits to protect circuit board components and maintain data integrity.

These devices are available in five model sizes: 5, 7, 10, 14, and 20mm, and feature a wide V DC voltage range of 5.5V to 615V.
See ZA Series Device Ratings and Specifications table for part number and brand information.

Help	Property	Value
Package Size/Form Factor Close Info	Package Size	10mm
This is the maximum continuous sinusoidal voltage, which may be applied to the MOV. This voltage may be applied at any temperature up to the maximum operating temperature of 85°C. Close Info	VMAX AC (V)	95
This is the maximum continuous DC voltage, which may be applied to the device. Close Info	Max Rated DC Voltage	127
This is the maximum rated transient energy, which may be dissipated for a single current pulse at a specified impulse and duration (2µs), with the rated V_RMS applied, without causing device failure. Close Info	Surge Energy (WTM) (J)	15
This is the maximum peak current, which may be applied for an 8x20µs impulse, with rated line voltage also applied, without causing greater than 10% shift in nominal voltage. Close Info	Peak Pulse Current (I_TM) 1xAmps (A)	2500
This is the voltage at which the device changes from the off state to the on state and enters its conduction mode of operation. This voltage is characterized at the ImA point and has specified minimum and maximum voltage ratings. Close Info	Nominal DC Voltage (V_NDC) (V)	150
This is the minimum voltage at which the device changes from the off state to the on state and enters its conduction mode of operation. This voltage is characterized at the 1mA point and has specified minimum and maximum voltage ratings. Close Info	V_NDC MIN (V)	135
This is the peak voltage appearing across the MOV when measured at conditions of specified pulse current amplitude and specified waveform (8x20µs). Close Info	Max Clamp Voltage (Vc) (V)	250
This is the maximum voltage at which the device changes from the off state to the on state and enters its conduction mode of operation. This voltage is characterized at the 1mA point and has specified minimum and maximum voltage ratings. Close Info	VNDC MAX (V)	165

Request a Sample

Check Distributor Stock Click Here

Find A Distributor

Design Support

Environmental Data

Environmental Info

Electrical Characteristics

Design Support

Environmental Data